
80-001113 SysLINK Administrator’s Guide Page 78
Connected – Serial Port Speed is 38400 baud
Connected – Serial Port Speed is 57600 baud
Connected – Serial Port Speed is 115200 baud
Connected – Serial Port Speed is 230400 baud
Modem Signal Behavior
The gateway serial ports should be set to DCE mode when modem emulation is enabled. A
DCE port is designed to be connected to a DTE device via a straight-through cable. Refer to
the gateway hardware manual for specific pinout information for your unit.
To emulate a modem properly, the gateway does the following:
DCD is asserted only when TCP/IP connection is
present and has been accepted via ATA or auto-answer.
DCD is de-asserted when connection is lost
The gateway monitors the device's DTR signal. The following behaviors occur on loss of
DTR only.
Drop to command mode, preserving connection
Drop to command mode, terminating any connection
Comentarios a estos manuales